Publicité
Les langues disponibles
Les langues disponibles
OPERATION:
Connect the passive speaker with the delivered speaker cable to the speaker output connector (16).
WARNING: connect the supplied passive speaker on the speaker output terminal only!
If required connect an external signal source like a CD-layer to LINE IN. Connect the device with an electric outlet
(230VAC / 50Hz)
LINE INPUT (DVD, CD-player etc.):
1. Connect the source (DVD-player, CD-player etc.) to the line input (15) on the rear panel.
2. Select by pressing input selector switch (2) LINE mode.
USB/SD:
1. Insert an USB (9) or SD device (10).
2. Push the input selector (4) to USB / SD mode.
3. Press PLAY button, MP3 begin to play.
MICROPHONE:
1. Insert the microphone to the MIC1 or MIC2 jack (4).
2. Adjust the MIC volume (7).
3. Adjust the echo (6) and delay (5) control.
Volume control can be adjusted with the master VOLUME (8). Make sure that when you turn on the active
speaker's volume control is minimal. Adjust the Equalizer (1+3) to get the right sound.
TROUBLE SHOOTING
Failure
NO POWER
NO SOUND
ONE SPEAKER WITHOUT SOUND
MICROPHONE NO SOUND
MICROPHONE HOWL
Possible cause
The power line is cut off or not connected
No power on the electric outlet
Wrong input, check input selection
The volume knob at lowest
Connection between master & slave unit wrong
Signal line was broke
The microphone not complete connected
Adjust the microphone volume
Change microphone
The microphone is too close to the speaker
Master volume is set to high
5
Publicité
