Publicité
Les langues disponibles
Les langues disponibles
Technical specifications
Polyvalent welding unit
Weight
Dimensions
Max power absorption
Input
Working temperature
Power cable
Welding cables
Screen
IP protection class
Max welding voltage
Working conditions
Input
The 00E8500 welding unit input should be exclusively:
230 V 50 Hz quality alternating current (maximum tolerance 20%);
We therefore recommend to ensure that the power source that you intend to use is up to
the required characteristics. If input to your polyvalent welding unit is from a voltage
generator, make sure that it is of the asynchronous type. Before purchasing a generator,
contact our Customer Service Representative to obtain more information on its required
characteristics.
If extension cables have to be used, pay special attention to the cable cross section to
length ratio, to prevent affecting your polyvalent welding unit smooth operation; in
particular, as far as extension table cross sections are concerned, the following chart
applies:
Cable Section
2.5 mm
4.0 mm
6.0 mm
WARNING: it is always advisable to use fully unwound extension cables.
230V
20 kg (44.1 lb)
340 x 220 x 500 mm (13" x 9" x 20" )
2000 VA
230V 50Hz / 60Hz
-18 °C to + 52 °C (0 °F to 125 °F)
Length 4 m (13 ft)
Length 4 m (13 ft)
Backlit LCD, 4 lines, 20 columns
54
42V
Recommended length
2
6 - 7 m (19.69 – 22.97 ft)
9 - 11 m (29.53 – 36.09 ft)
2
2
15 - 17 m (49.21 – 55.77 ft)
3
Publicité
