Denon AVR-1602 Mode D'emploi page 46

[] TROUBLESHOOTING
If a problem should arise,first check the following.
1. Are the connections correct ?
2. Have you operated the receiver according to the Operating Instructions ?
3. Are the speakers, turntable and other components operating property ?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
Disconnect the power immediately and contact your store of purchase
Symptom Cause Measures Page
• Power cord not plugged in securely * Check the insertion of the power cord plug 9
DISPLAY not lit and sound not produced * Tdrn the power off with the remote control 24
when power switch set to on unit after turning the POWER operaton
switch on
• Speaker cords not securely connected * Connect securely 13, 14
• Improper posit on of the audio function * Set to a suitable poston 25
button
o _ DISPLAY lit but sound not produced • Volume control set to minimum * Tdrn volume up to suitable level 26
• MUTING is on * Switch off MUTING 27
• Digital signals not input Digital input * Input digital signals or select input jacks to 26
selected which digital signals are being input
@S3
DISPLAY not displayed and the
"ON/STANDBY" LED flashes at a high
rate
• Speaker terminals are short-circuited
• Block the ventilat o_1holes of the set
• The unit s operating at continuous high
power conditions and/or inadequate
ventilation
• Switch power off, con_ect speakers 13, 14
propedy then switch power back o_
• Tdrn off the set's powei, then ventlate it 5, 14
well to cool it down
Once the set is cooled down, turn the
power back on
• Trim off the set's bowel, then ventlate it 5, 14
well to cool it down
Once the set is cooled down, turn the
power back on
_D
• Incomplete connection of speaker cords • Connect securely 13, 14
Sound produced only from one channel • Incomplete connection of input/output • Connect securely 9 14
cords
• Reverse connections of left and right • Check left and right connections 13, 14
Positions of nstruments reversed during speakers or left and right input/output
stereo playback cords
• Batteries dead • Replace with new batteries 15
• Move closer 15
% • Remote control u_fit too far from this unit
This u_fit does not operate propedy whe_l • Obstacle between this unit and remote • Remove obstacle 15
remote control unit is used control unit
Press the button
proper
• e
Different button is being presoed
Insert batteries properly 1
• G and 0 ends of battery inserted in reverse
cc
Note:
When a subwoofer has been connected and the virtual surround function is being used, the signal played from the subwoofer channel is LFE
to "SMALL" in the Speaker Configuration settings.
Making these settings will result in the low-frequency sounds of the front channel being played from the subwoofer
46