Publicité
Les langues disponibles
Les langues disponibles
UNPACKING AND ASSEMBLY
To Assemble the Battery Guard to the Powerhead
1. Remove the silver 5mm hex wrench that is included in
your parts bag.
2. Remove the nuts and bolts that are pre-installed into the
Battery Guard. Note the orientation of the nuts and bolts,
as they will be re-installed the same way.
3. Install the Battery Guard onto the handlebar.
SEE FIGURE 1
4. Re-install the nuts and bolts.
FIGURE 1
To Assemble the Auger to the Powerhead
1. Use the hex 3/16" wrench on the powerhead to remove
the bolt from the stem of the auger.
2. Insert the output shaft of the powerhead into the stem of
the auger and align the hole in the stem with the hole in
the output shaft. SEE FIGURE 2
BOLT
FIGURE 2
3. Replace the bolt in the stem of the auger and tighten
firmly with the included 3/16" hex wrench.
NOTE: There may still be some slop in the
connection between the output shaft and
the auger. This is normal.
Check for parts online at www.ioniceaugers.com or call 800-345-6007
HEX
WRENCH
POWERHEAD
DRIVESHAFT
AUGER
Optional:
Apply a small amount of oil or grease to the output
shaft before assembly to aid in disassembly at a later date.
To Charge the Battery for First Use
1. Connect the charger to a standard 120-volt outlet;
a red light should appear on the charger. Always
connect charger to standard 120-volt wall outlet
before inserting battery.
2. Charge the battery until the light on the charger
turns solid green.
3. To disconnect the battery, remove the plug from the
wall outlet then disconnect the battery from charger.
NOTE: Do not leave the battery on the charger
after the charge is complete. Unplug the charger
from the wall and remove the battery.
IMPORTANT
DO NOT LEAVE BATTERY ON POWERHEAD
WHEN AUGER IS NOT IN USE. ALWAYS DETATCH
BATTERY WHEN NOT USING THE ICE AUGER.
To Install the Battery
1. Turn the battery lock lever counterclockwise, to the
unlocked position.
2. Slide the battery onto the powerhead until it is fully seated.
3. Turn the battery lock lever clockwise, to the
locked position.
NOTE: The battery lock lever must be in the
unlocked position before the battery can be
slid onto the powerhead. SEE FIGURE 3
LITHIUM
BATTERY
FIGURE 3
Operator's Manual
ION Alpha Electric Ice Auger
BATTERY
LOCK
LEVER
5
Publicité
