Everbilt HDC75V Guide D'utilisation Et D'entretien page 7

Operation
Connecting power and testing
1
pump operation
NOTE: When these pumps are installed in a basin with a
sealed cover, switch operation cannot be observed. The sump
cover usually will have a spare that is plugged with a rubber
plug. This plug can be removed and switch operation can be
observed.
□
Plug the pump power cord plug into a 115V GFCI power
outlet.
□
Run water into the pump until the pump starts. Ensure the
gate valve in the discharge line is open.
□
Allow the pump to operate through several on/off cycles.
Care and Cleaning
WARNING: Ensure the pump is disconnected from the
power source before attempting to service or remove any
component.
WARNING: Do not remove the impeller. Removal of the
impeller requires special tools and can only be performed
by an authorized service center.
To clear a pump that is clogged with debris:
□
Unplug the pump to disconnect the electrical power.
□
Unscrew the six screws (1) on the volute (2).
□
Remove the volute (2) and the gasket (3).
□
Remove debris from around the impeller (4).
□
Reassemble the pump.
2
Operating the pump
□
When the float switch (1) moves up over the top of the
pump, the pump begins to operate. When the water lowers
to a certain level, the float switch (1) will turn the pump off.
NOTE: Ensure the pump is submerged in water. Running the
pump dry can damage the pump.
7
Please contact 1-844-883-1872 for further assistance.
1
1
4
3
2
HOMEDEPOT.CA