Publicité
Les langues disponibles
Les langues disponibles
Safety Information (continued)
CAUTION: Call an electrician when in doubt. The pump
should be connected to a separate 12 A circuit breaker or
12 A fuse block. Plugging into existing outlets may cause
low voltage at the motor. This could cause blown fuses,
tripping of motor overload or a burned out motor.
ELECTRICAL SAFETY
WARNING: Verify that the voltage and frequency of the
pump shown on the nameplate corresponds to those
available on the mains. The installer must make sure that
the electrical system is grounded in accordance with code.
WARNING: The plug and connection should be protected
from water splashes, and should never be used with an
extension cord. Before using the pump, always inspect it
visually (especially power cord and plug).
WARNING: Do not use the pump if it is damaged.
Warranty
This product is guaranteed for a period of three years from the date of original retail purchase against defects in materials and
workmanship.
Subject to the conditions and limitations described below, this product will be replaced with
specifications if the pump s cord end with cord tag and proof of purchase are returned to the retail store within the stated warranty period.
'
These warranties are subject to the following conditions and limitations:
a) a proof of purchase receipt verifying the purchase location and purchase data must be provided;
b) this warranty will not apply to any product or part thereof which is worn or broken or which has become inoperative due to abuse,
misuse, accidental damage, foreign materials in the system, operating at pressures in excess of recommended maximums,
neglect or lack of proper installation, operation or maintenance (as outlined in the applicable owner's manual or operating instructions) or
which is being used for industrial, professional, commercial or rental purposes;
c) this warranty will not apply to normal wear and tear or to expendable parts or accessories that may be supplied with the product which
are expected to become inoperative or unusable after a reasonable period of use;
d) this warranty will not apply to routine maintenance and consumable items such as, but not limited to, fuel, lubricants, vacuum bags,
blades, belts, sandpaper, bits, fluids, tune-ups or adjustments;
e) this warranty will not apply where damage is caused by repairs made or attempted by others (i.e. persons not authorized by the
manufacturer);
f) this warranty will not apply to any product that was sold to the original purchaser as a reconditioned or refurbished product (unless
otherwise specified in writing);
g) this warranty will not apply to any product or part thereof if any part from another manufacturer is installed therein or any repairs or
alterations have been made or attempted by unauthorized persons;
WARNING: If the pump is damaged, have it inspected by
an authorized service center.
WARNING: Make sure that electrical connections are
protected from flooding. Protect the plug and the power
cord from heat or sharp edges.
WARNING: The power cord must be replaced by qualified
personnel only. Grounding: The plug of the power cord has a
double grounding contact, so that grounding can be
achieved by simply inserting the plug.
OVERLOAD PROTECTION
This pump series has a built in thermal protection switch. The
pump stops if an overload condition occurs. The motor restarts
automatically after it has cooled down.
the same model or one of equal value or
3
Please contact 1-844-883-1872 for further assistance.
HOMEDEPOT.CA
Publicité
