Publicité
Les langues disponibles
Les langues disponibles
Energy Saving Tips
● Let food cool down before adding to the refrigerator. Put frozen food in the refrigerator compartment to thaw.
● Be sure to wrap food properly and wipe container dry before placing them in the refrigerator. This cuts down on frost build-
up inside the refrigerator.
● Organize and label food to reduce door openings.
Maintenance and Cleaning
When cleaning, do not reach your hands into the bottom of the refrigerator to avoid being scratched by sharp
metal corners.
Internal and External Cleaning
Any food residue in the refrigerator is liable to produce a bad odor, so the refrigerator must be cleaned regularly. The
refrigerator food compartment should be cleaned at least once a month.
Remove all shelves, crisper, bottle racks, cover board and drawers, etc. and clean them with a soft towel or sponge dipped in
warm water or neutral detergent.
Do not use bristle brush, steel wire brush, detergent, soap power, alkaline detergent, benzene, gasoline,
acid, hot water or any other corrosive or soluble items to clean the cabinet surface, door gasket, plastic
decoration parts, etc. to avoid damage.
Carefully wipe dry the door gasket and clean the groove. After cleaning, fix the four corners of the door gasket first and then
embed it segment by segment into the door groove.
Interruption of Power Supply or Failure of the Refrigerating System
● Take care of the frozen food in the event of an extended non-running of the refrigerating appliance (such as an interruption
of the power supply or failure of the refrigerating system).
● Try to open the refrigerator door as little as possible to keep food fresh longer.
If get any power outage notice in advance:
1. Adjust the thermostat knob to the high mode an hour in advance, so that food will get fully frozen (do not store new food
during this time). Reset the temperature mode to normal setting to save power supply.
2. You can also make ice with a watertight container and put it in the upper part of the freezer to help extend the time fresh
food can be stored.
Defrosting
1. Defrosting needs to be carried out when the ice layer reaches a thickness of 5mm / 0.19 in.
2. Turn the refrigerator power off and move your food and beverages to another cool place.
3. Do not use any tools to remove the ice or frost. It must be allowed to melt naturally.
4. Put a towel in the frozen compartment and on the bottom of the fresh compartment to dry any water.
5. The external drip tray in the compressor chamber may need to be emptied if there is too much melting ice.
Cleaning the Lamp
The LED lamp is used by the refrigerator for lighting which features low energy consumption and long service life. In case of
any abnormality, please contact the after-sales service.
CCD-0007759 Rev: 04-20-23
- 9 -
Publicité
