Publicité
IMPORTANT SAFETY INFORMATION
Please read instructions carefully and in their entirety. For Commercial or Industrial use only. (Not For
Residential Use)
Veuillez lire les instructions attentivement et dans leur intégralité. Pour usage commercial ou industriel
seulement. (Pas Pour un Usage Résidentiel)
ENGLISH
CAUTIONS
Always turn off power before installation, inspection, cleaning, or removal.
Do NOT bend the cable beyond its specified bend radius (~70mm).
Make sure all connections made are tight with no loose strands and with an appropriate IP rating.
Do NOT hot-plug, use dimmers, or switches on the DC side. Doing so will invalidate the warranty.
Do NOT reverse polarity.
Allow sufficient slack on supply cable to remove the luminaire from its position for any further maintenance.
Ensure supply cable is not in direct contact with any sharp objects.
ENVIRONMENTAL INSTALLATION CONDITIONS
Please note, luminaire and power supply unit ingress protection rating when deciding location
Luminaire suitable for dry, damp, and wet locations (IP66).
NOT to be stored or mounted exposed directly to the weather or excessive moisture.
Minimum 100mm [4"] distance between adjacent lighting equipment.
*
Minimum 100mm [4"] distance between lighting equipment and combustible materials (e.g. walls, ceilings)
*
Minimum 100mm [4"] distance between lighting equipment and other heat generating equipment (i.e. PSU).
*
Suitable for operation in an ambient temperature between 0C (32F) and 40C (104F).
Suitable for storage and shipping in a temperature between -30C (-22F) and 85C (185F)
Ensure the chosen location provides adequate airflow to allow passive cooling.
DISCLAIMER
All images are representative and may not be the actual product supplied, depending on the ordering options.
Avoid staring directly into light beam.
Wear appropriate Personal Protective Equipment (PPE) during installation and maintenance, such as safety glasses and
helmet.
The product should be installed by a suitably qualified individual following National Electric Codes (NEC) and local
codes/regulation.
Take extreme care when working with mains voltages.
There are NO user-serviceable parts inside this unit. Do NOT attempt any repairs yourself. Doing so will void the
manufacturer's warranty.
During operation, the housing may become hot. Avoid touching the unit with bare hands while in use.
Do NOT allow the product to operate in ambient temperatures above the maximum ambient stated on the datasheet.
Doing so will void any warranty.
Do NOT use aggressive cleaning agents. Any warranty will not cover any chemical damage to the seals.
Do NOT attempt to install more than one luminaire per PSU as per instructions.
Only use supplied components for installation.
*Imperial units are for reference only
.
Page 2 of 12
Page 2 of 12
Publicité
