When The Leak Lamp Flashes - Sony Marine Pack MPK-DVF Mode D'emploi

Recording
To attach the supplied wide-conversion lens
Attach the wide-conversion lens until it
fits firmly.
You can attach the wide-conversion
lens both on land and underwater.
Note
This wide-conversion lens is to be used
only underwater.
When using the supplied colour filter,
attach it on top of the wide-conversion
lens.
Using the supplied sunshade
The supplied sunshade for the LCD
monitor reduces glare from the LCD
monitor. Attach the sunshade as shown
in the illustration.
You can attach the wide-conversion lens, sunshade, and colour filter
underwater
If the image on the LCD screen is not clear because of the air remains between these
accessories and the marine pack, reattach them underwater.

When the LEAK lamp flashes

If water happen to leak in , the LEAK
lamp (yellow) flashes.
In such a case, remove the marine pack from the water as soon as possible, keeping it
horizontal. Be sure to surface following the safety rules for diving.
Dry the marine pack with a soft cloth and then open it.
To switch off the lamp, disconnect the remote control cable.
Check the cause of the leak.
If the camcorder is wet, take it to the nearest Sony dealer immediately.
14
-EN
LEAK lamp (yellow)
Attach the sunshade until
it fits firmly.