Bora Portamate PM5090 Manuel De L'utilisateur page 5

General Power Tool Safety Precautions
Using power tools of any kind can be dangerous if safe operating procedures are not followed. Recognizing the
hazards of each tool and using them with respect and caution will considerably limit the risk of personal injury.
1. Keep the work area well illuminated and clean. Cluttered benches, misplaced tools, messy floors and dimly lit
work surfaces can lead to injuries. Maintain a safe work environment by making sure you have an adequate
surrounding workspace that is dry and clear of debris.
2. Stay Alert – Watch what you are doing and use common sense. Do not operate tools while you are tired, under
the influence of drugs, alcohol or any medication. Avoid distractions because a moment of inattention while
operating power tools may result in serious personal injury.
3. Dress Properly – Do not wear loose clothing, gloves, neckties, rings, bracelets or other jewelry that may get
caught in moving parts. Non-slip footwear is recommended. Long hair must be contained.
4. Always Wear Safety Protection – Recommendations for power tool usage include: safety glasses that comply
with ANSI Z87.1 standards, earmuffs to reduce noise exposure, and a face or dust mask to prevent inhalation of
sanding dust.
5. Keep Children and Visitors Away – Operate tools at a safe distance from onlookers and distractions. Be cautious
of flying debris and sparks if onlookers are present. Store power tools locked up and out of the reach of
children. Tools are very dangerous in the hands of untrained users.
6. Do Not Overreach – Take care to maintain proper footing and balance at all time. Clamps and other practical
ways to secure and support the workpiece or to keep power cords from moving during operation make work
safer. Holding your work by hand or against your body for support is unstable and may lead to loss of control
and injury.
7. Electrical Safety – If a tool is equipped with a three-prong plug then it is specifically designed for a grounded
three-hole electrical receptacle. If an adapter or extension cord is used, always use a three-prong type attached
to a known grounded electrical connection and NEVER remove the third prong. Do not abuse the cord. Keep the
power cord away from heat, oil, water and sharp objects. Grasp the plug when disconnecting from the power
receptacle and do NOT pull from the cord. Do not use electrically powered tools in the presence of flammable
gases or liquids.
8. Do not carry a plugged in tool. Avoid accidental starting by making certain the switch is in the OFF position
before plugging in the power cord. Never leave a tool running unattended.
9. Do Not Force Tool – The tool will do a better job and be safer sanding at a moderate rate.
10. Check Tools Regularly – Inspect tools periodically for misalignment or binding of moving parts, breakage or
damaged parts. Repair or replace any damaged parts before further operation. Follow the instructions on
recommended accessory changes and lubrication maintenance. Do not use a tool if the switch does not turn the
tool on and off correctly. Storing tools in a dry location will inhibit performance damage due to rust.
11. Use only approved parts and accessories. The use of replacement parts from unauthorized sources may present
a risk of personal injury. Accessories that may be suitable for one tool may become hazardous when used on
another tool.
12. Warning: Work in a well ventilated area at all times. Dust from wood, plastic and other materials may be
hazardous to your health so you should always wear a dust mask when sanding, sawing, grinding, drilling, etc.
Many power tools provide built-in vacuum attachment dust ports designed to provide proper dust removal and it
is highly recommended that you have one properly fitted to your tool when in operation to reduce your exposure
to harmful chemicals.
4