Tefcold UHD 200 Mode D'emploi page 14

Indications LED's:
Flashing, indicates that a delay is in progress.
Switched on, indicates that the compressor is activated.
Switched on, indicates that defrosting is activated.
Switched on, indicates that the evaporator fan is activated.
Display set temperature:
Press this key and the display will show the set temperature.
The display will return to normal reading after 15 sec.
Set new temperature:
Press this key and the display will show the set temperature. '
Press this key to increase the value.
Press this key to lower the value.
Press this key to save the new settings. The display will flash with the new value and will
then return to normal reading.
Alarm codes:
'P1' Flashing in the display: indicates that the cabinet sensor is defective.
The cabinet will strive to keep the set temperature until it has been repaired.
'P2' Flashing in the display: indicates that the evaporator sensor is defective.
This does not influence the operation of the cabinet, but should be repaired as soon as
possible.
Changing of parameters:
Press this key continuously for 5 seconds to access the list of parameters.
The display will show the name of the parameter.
Press this key to scroll up through the parameter-list.
Press this key to scroll down through the parameter-list.
Press this key to select the parameter to change, the display will show the actual value, use
the up/down keys to change the value and confirm with 'Set':
The display will return to normal reading after 15 sec.
See table of parameters from page 36.
Defrosting
'- flashing.
14