Publicité
WARNING
1. Do not unscrew the clamp front screw
(protected with warning adhesive), as it
may lead to loss of warranty and damage
to the product (Fig.1).
2. Once oriented, make sure the clamp is
tightened all the way so there is no
movement:
a. Firmly fasten the security screw (Fig.2)
b. Make sure the shift is tightly locked (Fig.3).
c. Do not use the tower and its fixing accessories improperly
(such as a lug for lifting weights).
d. To turn the clamp make sure not to unfasten the safety
screw completely.
e. During the hooking/unhooking/rotation phases, the
tower must always be held, possibly with the help of a
second person.
3. Pay attention not to set down/hit the back of the product to avoid
damage to the aluminium logo.
4. During navigation it is mandatory to turn off any light on the tower,
whether it is a fixed color, RGB or flashing light, whether it is front (speaker),
or rear (rear RGB logo). The manufacturer can not be held responsible for any
sanctions or accidents caused.
5. It is strongly recommended to have the product installed by a dealer or by a professional who has the necessary
equipment and experience to properly install this product. If you prefer to perform your own installation, please
read this manual completely before beginning the process.
6. Do not use chemicals such as ammonia or any cleaning material that contains abrasive substances on the product.
7. Before installation, disconnect the battery terminals to prevent damage to the unit, fire and/or possible injury.
8. Be careful not to cut or drill into fuel/gas tanks, brake/ vacuum/hydraulic lines, or electrical wiring when working
on any vehicle. If installing in a boat, take care not to drill through the main hull.
9. Drill an appropriate diameter hole for wire routing and deburr the hole so there are no sharp edges. It is
also recommended to install a rubber grommet in this hole to protect the wire.
10. Connect input cable with extension cable and insulate each separate wire from the others and isolate all wires from pipe.
11. After installing the product, tighten the screws. It is also recommended to use a thread locker to block the screws.
12. For clamp version, use the appropriate length screws (Set A/B included) based on the size of the round pipe where
you are mounting them (38/1.5 ÷ 76/3 mm/in.).
13. In case of speaker damage, after it is replaced, make sure the speaker screws are tight but do not over tighten.
14. These speakers are designed to be water and spray resistant, but they are not designed to be submerged or to
withstand high-pressure water spray. Please exercise care when washing your boat to avoid damaging the
speakers. Do not install on personal watercraft or any other vessel likely to be under water for even a short time.
15. When installing speakers in your vessel, it is extremely important that the speakers and their supporting
structures are firmly secured to avoid causing harm to persons or property, in case of collision also. Please review
the mounting information carefully and use the supplied accessories to mount this product.
16. The tweeters and lighting circuit (when this is available) are permanently fixed to the grille (unless otherwise specified).
Do not attempt to remove the grille/tweeter/LED lighting from the grille as any damages caused not be covered
under warranty.
17. The crossover is equipped with an electronic tweeter protection circuit designed to minimize the risk of damages
to the tweeter. This electronic device monitors the current going to the tweeter and limits the tweeter signal when
it senses an overload. Should this occur while listening to the audio system, simply reduce the volume for a few
seconds to reset the protection circuit.
18. When assembling, make sure that the connectors pins are dry and free of condensation/moisture.
14
Do not remove this
screw! Warranty void
(Fig.1)
(Fig.2)
(Fig.3)
Publicité
