SCOPREGA K6131295 Notice D'instruction page 11

CONNECTION OF THE KIT TO THE INFLATOR
9.
1. Open the carton and take the battery out.
2. Put the battery in the inflator pocket and connect the RED power connector to the inflator.
WARNING
NEVER LEAVE THE INFLATOR SWITCHED ON UNATTENDED. OVERINFLATING AN
OBJECT CAN CAUSE SERIOUS CONSEQUENCES. CHECK THE MAXIMUM PRESSURE
RECOMMENDED BY THE MANUFACTURER.
10. TROUBLESHOOTING
PROBLEMA
Unit will not
Start
Unit will not
inflate
10.1 ACCESSORY WARNING
Recommended accessories for your inflator are available from your dealer or authorised service
centres.
WARNING
THE USE OF ANY ACCESSORIES NOT RECOMMENDED FOR THIS INFLATOR CAN BE
DANGEROUS.
POSSIBILE CAUSA
Battery LOW
ON push button not ON
The safety fuse is blown
Unit is damaged
Wrong port connected
Wrong setting on the pressure knob
POSSIBILE SOLUZIONE
Recharge the battery by the
110-240Vac battery charger
Push ON PB
Replace the fuse with one of the same
size (30 A).
Contact SCOPREGA
Service Center
Connect the air hose to the proper
port.
Adjust settings.
11