SurfaceMaxx SGY-PWA1088 Manuel D'instructions

Pro Foam Cannon Quick Setup:
With the sprayer removed from the bottle, fill the bottle with warm water and soap made for foam cannons (not
included). Use recommended water to soap ratio on the soap label.
ASSEMBLY INSTRUCTIONS
1. Attach the bottle directly to the sprayer.
Turn sprayer "clockwise" until tight
(see Figure 1-1). Do not overtighten.
2. Additional inlet threads in the spray top
will attach directly to a 16-oz soap bottle
(not included, see Figure 1-2).
3. Connect the Pro Foam Cannon to the quick connect
fitting on your spray gun or wand.
Note: Pressure washer should be turned off during
connection or the spray gun trigger should be in the
locked position.
OPERATING INSTRUCTIONS
1. The SurfaceMaxx Pro Foam Cannon features a 32 oz. bottle. The draw ratio during use is approximately
1:10 detergent to water. For best results, foam cannon soap is recommended.
2. The air intake knob (A) adjusts the amount of foam. Turn
clockwise for more foam and turn counter clockwise for less
foam (see Figure 1).
3. The cone (B) adjusts both the direction of the spray pattern
(horizontal or vertical) and the width of the spray pattern.
4. To adjust the spray pattern, pull outward on the cone
and turn it clockwise or counter clockwise depending
on what direction you want and then push the cone
back in towards the intake knob (see Figure 2-1).
5. To adjust the width of the spray pattern, make sure
the cone is pushed in and then turn the cone clockwise
for a bigger fan pattern or counter clockwise to reduce
the amount of fan. It can be reduced down to a straight
stream (see Figure 2-2).
INSTRUCTION SHEET
Pro Foam Cannon
1-1
2-1
Pull
1
MODEL #SGY-PWA1088
1-2
2
1
A
2-2
B
B
www.surfacemaxx.com