Kenmore BC4040 Manuel D'entretien Et D'utilisation page 20

Always follow all safety precautions when performing maintenance to the PowerMate
WARNING
Electrical Shock or Personal Injury Hazard
Always turn off and unplug vacuum cleaner before performing maintenance to the
vacuum cleaner. Failure to do so could result in electrical shock or personal injury from
vacuum cleaner suddenly starting.
BELT CHANGING AND BRUSHROLL CLEANING
TO REMOVE BELT
1. Press handle release pedal and lower the
swivel. Turn PowerMate
and remove the four (4) screws securing
base to PowerMate
Side Latch
(Not Shown)
Rear
Latch
Handle
Release
Pedal
2. Turn PowerMate
the rear and side latches (A flat blade
screwdriver may be required).
POWERMATE
®
upside down
®
cover.
Swivel
Rear
Side Latch
Latch
®
right side up. Loosen
®
CARE
3. Grasp cover by rear and pull up to
remove it from base.
4. Lift brushroll assembly out and remove
worn belt.
Brushroll
5. Check and clean end cap areas.
See picture on page 21 for complete
brushroll assembly.
- 20 -
®
.