Kenmore BC4040 Manuel D'entretien Et D'utilisation page 16

The vacuum cleaner creates suction that
picks up dirt. Rapidly moving air carries
the dirt to the dust bag through the airflow
passages. The dust bag lets the air pass
through, while it traps the dirt.
For best cleaning results, keep the
airflow passage open. Check the
starred ( ) areas occasionally
for clogs. Turn off and unplug
vacuum cleaner from outlet
before checking.
TO CHECK FOR CLOGS:
• Check dust bag and change if full. See
DUST BAG CHANGING (page 17).
• Check motor safety filter and exhaust
filter and clean or replace if dirty. See
MOTOR SAFETY FILTER CLEANING
(page 18) and EXHAUST FILTER
CHANGING (page 19).
• Check PowerMate
in the belt path area or in the brushroll
area. Carefully remove any string or
debris located on the brushroll or end
caps. See TO CLEAN BRUSHROLL (page
21).
CLEANING EXTERIOR AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. To clean exterior, or to reduce static
electricity and dust build-up, wipe outer
surface with a clean, soft cloth that has
been dipped in a solution of mild liquid
detergent and water, then wrung dry.
Wipe dry after cleaning.
CANISTER CARE
REMOVING CLOGS
®
for any dirt or debris
If the vacuum cleaner still has poor
suction, do the following:
1. Connect the hose to the canister and
turn vacuum cleaner on. Check the end
of the hose for suction. If there is good
suction on the hose handle, there is no
clog in the hose. If the suction is bad,
remove any dirt or debris in the hose
and handle.
2. Connect hose handle to wand. Check
the end of the wand for suction. If there
is good suction at the end of the wand,
there is no clog in the wand. If the
suction is bad, remove any dirt or debris
in the wand.
3. Check PowerMate
dirt or debris.
CAUTION
Do not use attachments if they are wet.
Attachments used in dirty areas, such as
under a refrigerator, should not be used
on other surfaces until they are washed.
They could leave marks.
- 16 -
®
swivel. Remove any