Publicité
Les langues disponibles
Les langues disponibles
GB
5
1
3
or
4
Initialization procedure:
1. Cut off power to the hood
2. Power the hood again
3.Within the first 5 sec, press the light button and release it after the lights turn on (the control
must be turned on via key 3)
4. Within 5 sec, press the motor key and release it
Now you have to wait for about 10 seconds – then you can use the hood normally.
Notes: after 4 hours from the last use of a key, the hood turns off automatically.
Should there be interferences with other nearby remote controls, carry out the code change
procedure.
Should it be required to replace the radio control, the frequency of the electronic system of the
new radio control must be calibrated again via the initialization procedure.
Procedure for generating a new code for the radio control.
The radio control is supplied with default codes. If you want to generate new random codes you
need to follow the procedure below: simultaneously press the plus and minus keys for at least
10 seconds; the LED will turn on, then press the two buttons again (within 3 seconds). The LED
flashes three times to indicate that the operation has been completed. Once you changed the
radio control you must run again the initialization procedure.
Note: 4 hours after the last key touch, the fan will automatically turn off.
All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for 7 minutes,
after which it automatically returns to the last non-timed speed.
1: + motor
2: On/Off motor
3: - motor
4: On/Off light
5: Led
2
Note: the LED on the hood indicates the various speeds: green
1st speed, orange 2nd speed, red 3rd speed and flashing red 4th
speed.
„If the remote control unit is changed, the appliance must be
reset to the frequency of the new unit as follows:
OPERATION
28
Publicité
