Panasonic PV-D4734S-K Mode D'emploi page 55

*Important: If a remote control button does not work when pressed,
press the DVD button on the remote and try the button again.
PROGRESSIVE OUT (DVD only) PROGRESSIVE OUT
Sets the Component Video Output Connector (p. 10, 13)
to output the Progressive scan signal.
1
Press ACTION
to display DVD MAIN MENU.
2
DVD MAIN MENU
DISC LANGUAGES
AUDIO OUTPUT
ST I L L MODE : AUTO
TV MODE : 4 : 3 P a n & S c a n
PROGRESSIVE OUT : OFF
SELECT :
SET : SET
END : ACTION
OFF: Progressive scan signal is not output.
ON: Progressive scan signal is output from the
Component Video Output Connector.
3
Press ACTION
to exit this mode.
Notes
• If the television is not progressive compatible,
a progressive scan picture is not available.
Connect the Video Output or S-Video Output
connector (see p. 12, 13) and set PROGRESSIVE
OUT to "OFF".
• CONSUMERS SHOULD NOTE THAT NOT ALL
HIGH DEFINITION TELEVISION SETS ARE FULLY
COMPATIBLE WITH THIS PRODUCT AND MAY
CAUSE ARTIFACTS TO BE DISPLAYED IN THE
PICTURE. IN CASE OF 480 PROGRESSIVE SCAN
PICTURE PROBLEMS, IT IS RECOMMENDED
TO SET PROGRESSIVE OUT TO "OFF".
IF THERE ARE QUESTIONS REGARDING OUR TV
SET COMPATIBILITY WITH THIS MODEL 480p
DVD/VCR DECK, PLEASE CONTACT OUR
CUSTOMER SERVICE CENTER.
D4734S-K P36-64 (040202).p65
Press
to select "PROGRESSIVE
OUT," and
press SET repeatedly
for mode. (See below.)
55
ACTION
SELECT
SET
55
2004/02/02, 15:13