Panasonic PV-D4734S-K Mode D'emploi page 35

Copying Your Tapes (Dubbing)
Connection
VCR/ Camcorder
(Hi-Fi)
OUT
VIDEO VIDEO
L
AUDIO
AUDIO1
R
Connect VIDEO OUT terminal on Playing VCR to VIDEO IN terminal on DECK.
1
To monitor the dubbing, also connect TV as shown.
Connect "L" and "R" AUDIO OUT terminals on Playing VCR to "L" and "R"
2
AUDIO IN terminals on DECK.
In place of Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit's Audio/Video outputs to DECK.
Playing (Source) VCR
1
Insert a pre-recorded tape.
2
3
Press PLAY, then PAUSE
immediately to enter PLAY/PAUSE
mode.
The operation of steps 4 and 5 must be done on the
playing and recording VCRs at the same time.
4 Press PLAY to start dubbing.
Playing VCR starts playback.
5
Press STOP to stop dubbing.
To Monitor Dubbing on TV
1 Turn TV on and tune to the Recording
VCR channel (CH 3 or CH 4).
2 If Auto VCR/TV (see p. 32) is set to
"OFF," press VCR/TV on the remote
for VCR mode.
• Dubbing tapes protected with Copy
Note
Guard will result in poor quality
recordings.
Caution:
• Unauthorized exchanging and/or copying of copyrighted recordings may be
copyright infringement.
• Please note that some tapes cannot be dubbed on DECK.
Also, it is not possible to dub DVD/ CD to VHS tapes using DECK.
• When appears on the screen while a button is being operated, it means
that the corresponding operation is prohibited by DECK or the disc.
D4734S-K P26-35 (040202).p65
DVD/VCR DECK
IN FROM ANT.
OUT IN 1
VHF/
VHF/UHF
L
UHF
OUT TO TV
R
Recording (Editing) DECK
Insert a blank tape with record tab.
Press INPUT to set DECK Input mode to
LINE for Video Input.
(See "Selecting the Input Mode" below.)
Press REC, then STILL/PAUSE
immediately to enter REC/PAUSE
mode.
Press STILL/PAUSE to start dubbing.
DECK starts recording.
Press STOP to stop dubbing.
Selecting the Input Mode
Method 1: Press INPUT repeatedly.
Method 2: Press CH
Press
LINE2
• "L1" or "L2" lights up on Multi Function Display
(about 4 seconds) when LINE1 or LINE2 is selected.
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
35
TV
Front of DECK
VIDEO IN 2 L-AUDIO IN2-R
(Audio/Video In Terminals
on the front of DECK are
available)
Channel Number ↔ ↔ ↔ ↔ ↔ LINE1 ↔ ↔ ↔ ↔ ↔ LINE2
/ .
Display will change as below.
1 2 3
Press
(CABLE)
(TV)
or
LINE1 125 69
2004/02/02, 15:13
35