Grandstream Networks UCM6301 Guide D'installation Rapide page 4

HARDWARE INSTALLATION:
UCM6301/6302/6300A/6302A can be installed on the desktop or on the wall, and
can be installed in a cabinet on a pallet. Please refer to the following steps for
correct installation.
Wall Installation:
1. Before formally installing the expansion screws, clarify the speci昀椀c location of
the expansion screws and make a mark.
2. Pay attention to the following points when drilling: First, the drill bit model (ap-
erture) used for drilling refers to the maximum diameter of the expansion tube
equipped with the expansion screw; second, the drilling depth refers to the
length of the expansion tube, slightly deeper than 5~10mm .
3. After the expansion tube is inserted into the punched hole, it can be tapped
lightly with a hammer to make the expansion tube and the wall 昀氀at.
4. Fix the equipment well and 昀椀x the self-tapping screw in the expansion tube.
Self-tapping Screw Speci昀椀cations:
Punch: JMB-40B
Use line: 1018
Rolling diameter: Φ3.25MM
Dental plate: M4-16T
Expansion Screw Speci昀椀cations:
This size measures the
side with no opening
Schematic Diagram of Wall-mounted Installation:
2.50±0.2
+0.5
*30.00
-0.5
~3~
CONNECTING UCM6301/6302/6300A/6302A:
UCM6302/6302A Rear view
LAN port FXS ports
Reset
DC 12V
WAN port
Heartbeat port
UCM6302/6302A Front view
UCM6300A Rear view
LAN port
Reset
DC 12V
Heartbeat port
WAN port
UCM6300A Front view
Note: The number of FXS, FXO and USB ports depends on the
UCM6301/6302/6300A/6302A model; among them, UCM6301 supports 1 FXS,
1 FXO and 1 USB port.
1. Connect one end of an RJ-45 Ethernet cable into the WAN port of the
UCM6301/6302/6300A/6302A.
2. Connect the other end of the Ethernet cable into the uplink port of an Ethernet
switch/hub.
3. Connect the 12V DC power adapter into the 12V DC power jack on the back of
the UCM6301/6302/6300A/6302A. Insert the main plug of the power adapter
into a surge-protected power outlet.
4. Wait for the UCM6301/6302/6300A/6302A to boot up. The front LCD display
will show the UCM's hardware information when the boot process is com-
pleted.
5. Once the UCM6301/6302/6300A/6302A is successfully connected to network
via WAN port, pressing the "Home" button will allow you to get the IP address
as well as other information.
6. (Optional) Connect PSTN lines from the wall jack to the FXO ports, connect
analog devices (phone and fax) to the FXS ports (UCM6301/6302/6302A
only).
FXO ports
Ground
SD Card slot
USB ports
Ground
SD Card slot
USB port
~4~