Manutan AUS Typ 90 Mode D'emploi page 10

1. Models
1.1 Type 90 – safety cabinets as per EN 14470-1
1.2 Type 30 – safety cabinets as per EN 14470-1
1.3 G 30 – gas cylinder safety cabinets as per EN 14470-2
2. Technical data / Drawings
see Annex 1
3. Intended uses
- Type 30 / Type 90 safety cabinets are suitable for the storage of flammable liquids at the
workplace while observing the relevant national rules and regulations.
- G 30 gas cylinder safety cabinets are suitable for the storage of gas cylinders at the
workplace while observing the relevant national rules and regulations.
4. General safety information / Warranty
• For the operation of your safety cabinet you must observe the national rules, regulations and
laws that are applicable.
• Before starting to use your safety cabinet you must carry out a functional check in order to
recognise any damage that may have been caused by transport, importation or improper
installation!
• Safety devices must be checked at regular intervals – this should only be carried out by our
trained specialists! This guarantees proper and safe long-term storage
• Warranty: in accordance with our General Terms and Conditions. See also item 13.
• Please also observe your duty of exercising due care – any damage must be remedied and
spilt liquids removed immediately!
• The area in which the doors open must be kept free and clean.
• Doors and drawers should only be open when items are being removed from or placed in
the safety cabinet – keep the doors/drawers closed!
• Please observe the maximum amounts that can be stored, shelf loading, etc., as per
Annex 1 and the markings on the door/drawer.
• The safety cabinets are not intended for the storage of aggressive substances (e.g. acids and
alkalis, corrosive gases) as these could corrode the interior fittings and the exhaust air
extraction system! Our special acid and alkali safety cabinets should be used for this.
• Before storing substances (e.g. reagents) you must check that the cabinet surfaces are
resistant to them.
• To comply with EN 14470-1 the collection trough must be able to contain a minimum volume
of 10% of the contents of the containers stored above it, or at least 110% of the contents of
the largest single container – do not store too large containers!
• See 7.4 perforated cover plates
5. Transport
storeLAB ® safety cabinets must only be lifted from beneath by using a suitable means of
transport; they must be transported upright. Tilting during lifting and transport must be avoided
at all costs. Tilting could cause damage that could limit or destroy the functioning of the built-in
safety devices. You must also avoid jolting the cabinet when unloading it.
11