Publicité
Les langues disponibles
Les langues disponibles
Replacing I/O Terminal Cover
1.
Run cables through bottom of I/O terminal cavity across foam gasket. All cables must exit toward
bottom of display to retain seal when I/O terminal cover is installed. Do not run cabling through
the top or sides of I/O terminal cavity. Leave approximately 1/2" (13mm) between cables to
retain seal when I/O Terminal Cover is installed.
2.
Replace I/O terminal cover onto I/O terminal guides, keeping cables between the bottom
gaskets.
3.
Replace and tighten screws until I/O terminal cover gasket is fully compressed to back of display.
Failure to follow these instructions can result in the product being damaged or destroyed, voiding
the warranty.
guides
•
Ensure cord bend radius does not exceed limits set by
the manufacturer.
•
Ensure cords are seated properly in the cable channels
to avoid potential damage to cords when I/O terminal
cover is installed.
•
Do not run cables through the top or sides of I/O terminal
cavity. All cables must exit toward bottom of display to
retain seal when I/O terminal cover is installed.
CAUTION
guides
CAUTION
Do not overtighten screws
10
2023-09-19
Replace
#:180-9178-2
(2024-05-17)
Publicité
