Expression Pedal - HEADRUSH MX5 Guide D'utilisation Rapide

Expression Pedal

The expression pedal can control two parameters (in Classic Mode) or two sets of parameters (in
Advanced Mode). Use the toe switch to switch between them—Expression Pedal A or B.
To activate the toe switch, move the "toe end" of the expression pedal so it touches the
MX5, and then press down.
Note: When you save your rig, the current selected Expression Pedal state (A or B) will be
saved and then recalled when you load the rig again.
The column of four boxes represents the expression pedal settings. You can
assign one or more continuously adjustable parameters (ones with a range of
values) to the expression pedal.
To set the expression pedal mode, tap the button above Range in the
upper-right corner to select Classic or Advanced.
Classic: You can assign one parameter to each expressional
•
pedal (A and B). Using the toe switch will select the other
expression pedal and deactivate (bypass) the current
expression pedal's parameter. For instance, if you assign a
wah pedal to Expression Pedal A and a volume pedal to
Expression Pedal B, only one of them will be active at any
time; when you are controlling the wah pedal, the volume
pedal will be bypassed, and vice versa.
Advanced: You can assign up to four parameters to each
•
expression pedal (A and B). Moving the pedal will adjust all of
its assigned parameters simultaneously. Using the toe switch
will select the other expression pedal and leave the current
pedal's parameters active and at their maximum values.
To assign a parameter to the expression pedal:
1. If the Assign button is not on, tap it.
2. Tap a box under the Assign button.  indicates an empty box.
3. In the list that appears, tap the model with the parameter you want to
assign.
4. In the list that appears, tap the parameter you want to assign.
Tap Unassigned  to unassign that box.
To swap two assignments (while in Advanced Mode), tap and drag one of
them over the other, and then release it.
To set the range of an assigned parameter:
1. If the Range button is not on, tap it.
2. Tap a value under the Range button.
3. Turn the encoder to set the desired value as a percentage of the
parameter's entire range. Press the encoder or tap elsewhere to
confirm the value.
13