Publicité
Les langues disponibles
Les langues disponibles
lid, the outer surfaces are hot. Do not use the appliance close to objects
which can be damaged by steam.
WARNING
1.
Always use cold water when filling the kettle.
2.
The water level must be between the MAX. and MIN. levels!
Hot water may spurt out if the kettle is overfilled.
3.
Switch off the kettle before removing it from the base.
4.
Always make sure the lid is well closed.
5.
The base and kettle body should not be wet.
6.
Only use the kettle in combination with its original base.
You may not use the kettle to heat any other liquids than water. Never put in the kettle tea bags, loose
tea or any other ingredients for making beverages!
GB
USING THE APPLIANCE
Fill the kettle with clean, cold and potable water up to max. level before first use, switch it on and bring the
water to a boil. Then pour the water out and repeat the procedure at least five times. With this procedure you
will properly clean the kettle and remove any possible taste of plastic. If you have the impression that you taste
plastic from the boiled water, we recommend to repeat the procedure. It is also recommended the leave the
empty kettle open for 24 hours. The kettle material coming into contact with water is certified as harmless to
health. Any slight "smell" or "plastic taste" during initial use after unpacking kettle is a normal phenomenon and
should not be cause for return of the appliance.
1.
Fill the kettle with water. Do not overfill the kettle, watch the water level indicator.
2.
Place the kettle on its base.
3.
Switch the appliance on after putting the plug into the outlet. The On indicator signals heating of water.
4.
The kettle will switch off automatically after the boiling process has finished.
5.
Unplug the cord from the outlet.
6.
Do not open the lid when pouring the water out.
MAINTENANCE AND CLEANING
Before cleaning the kettle always disconnect the power supply plug from the wall outlet and make sure the
kettle is cold!
Wipe the outside of the appliance with a moist cloth and then wipe dry.
The scale filter can be removed for the cleaning process. Use designated and commonly available agents to
remove scale from the kettle.
TECHNICAL INFORMATION
Capacity 1 l
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 900–1100 W
WARRANTY: The following situations void the warranty:
Incorrect or inappropriate handling of the device, failure to observe safety measures applicable to the device,
the use of force, alterations or repairs made by a party other than authorized service center.
Components subject to normal wear and tear are not covered under warranty.
26
Do not immerse in water!
Publicité
