Installing/Removing Battery Pack; Using The Sprayer - Ryobi PSP01 Manuel D'utilisation

 Fill the tank with the desired amount of liquid (up to 15 oz).
NOTE: To ensure proper operation of the sprayer, do
not fill past the max fill line.
 Screw the cap back onto the tank, making sure it is
tightened securely.
NOTE: Wipe the outside of the tank with a dry cloth and
clean up any spills before inserting the tank.
 Insert the tank into the sprayer at an angle.
 Push the base of the tank into the groove at the base of
the sprayer until it clicks into place.
 Lock the latches to secure the tank in place.
 Reinstall the battery pack.
NOTICE :
It is important to thoroughly clean the unit after each use.
Allowing liquid to remain in an idle tool for an extended
period may cause its moving pieces and connectors to
seize up.

INSTALLING/REMOVING BATTERY PACK

See Figure 4, page 11.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and the battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.

USING THE SPRAYER

See Figure 5, page 11.
WARNING:
Improper application of chemicals or solutions can result
in SEVERE INJURY or DEATH. Follow all CDC and EPA
guide lines. Follow the chemical manufacturer's safety
instructions and guidelines listed on the SDS sheet.
OPERATION
Risk of fire or explosion. Spray area must be well-
ventilated and away from sparks or flames.
 Remove the battery pack.
 Remove the tank and unscrew the cap.
 Carefully pour up to 15 oz. of liquid into the tank.
 Replace the cap.
 Reinstall the tank and latch to secure.
NOTE: Wipe the outside of the tank with a dry cloth and
clean up any spills before inserting the tank.
 Install the battery pack.
 Direct the sprayer nozzle directly at the surface areas you
wish to treat.
NOTE: Make sure to stand far enough from the object
being sprayed to prevent the spray from splashing back
onto you.
 Squeeze and hold the switch trigger while the unit primes.
This may take several seconds. Continue holding the
trigger until unit begins to spray.
 Spray on a dry surface using long, even, overlapping
strokes.
NOTE: While the sprayer is in use some dripping from
the nozzle may occur, this is to be expected.
 Release the switch trigger to stop the spray.
 When you are finished with the sprayer, remove the bat-
tery pack.
 Remove the tank and unscrew the cap.
 Return any unused fluid to its original container, and
thoroughly clean the sprayer.
 Thoroughly clean the sprayer and tank before transport-
ing or storing the unit and before switching to a different
chemical. See Cleaning the Unit later in this manual.
NOTE: Wipe the outside of the tank with a dry cloth and
clean up any spills before inserting the tank.
 Thoroughly wash your hands and any area where skin
has been exposed to the spray.
8 – English
WARNING: