Operation; Applications - Ryobi RYAC803 Manuel D'utilisation

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.

APPLICATIONS

You may use this product for the purpose listed below:
 Removing snow from desired areas such as driveways
and sidewalks
WARNING:
Always disconnect snow blower from power supply when
you are assembling parts, making adjustments, cleaning,
or when not in use. This will prevent accidental starting
that could cause serious personal injury.
CONNECTING TO POWER SUPPLY
See Figure 6.
This product is designed with a cord retainer that prevents
the extension cord from being pulled loose while using.
 Form a loop with the end of the extension cord.
 Insert loop portion of extension cord through opening
and place over cord retainer.
 Slowly pull loop against cord retainer until the slack is
removed.
 Plug product into extension cord.
NOTE: Failure to remove all excess cord slack from cord
retainer could result in plug loosening from receptacle.

OPERATION

STARTING/STOPPING THE SNOW BLOWER
See Figure 7.
 Connect the snow blower to power supply.
NOTICE:
Always secure extension cord to unit by using cord
retainer. Failure to use cord retainer may result in damage
to the unit and/or extension cord.
 Press and hold the start button. Pull the bail toward the
handle and release the start button to start the snow
blower.
 To stop the unit, release the bail.
ADJUSTING THE CHUTE
See Figures 8 - 9.
The chute can be adjusted to change both the direction and
the distance to assist you in moving snow away from one
area and placing it in another.
The direction of snow removal can be adjusted up to 180º.
 Turn the chute rotation lever to the left to rotate the chute
to the left.
 Turn the chute rotation lever to the right to rotate the
chute to the right.
The distance the snow is moved is adjusted using the chute
deflector handle. Squeeze the two parts of the chute deflec-
tor handle together to adjust.
 Move the chute deflector forward (up) to increase the
distance the snow will be thrown.
WARNING:
Do not force the chute so far forward that a gap appears
between the deflector and the chute itself. Snow or other
debris could be thrown through the gap back at the
operator, resulting in serious personal injury.
 Move the chute deflector backward (down) to decrease
the distance the snow will be thrown.
OPERATING TIPS
WARNING:
Never use snow blower on frozen lakes, rivers, or similar
surfaces. Death or serious injury could occur if the ice
breaks.
WARNING:
Never use the snow blower on a rooftop or other unstable
surface, which can result in death or serious personal
injury.
10 — English