Publicité
Les langues disponibles
Les langues disponibles
Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only
one single work top under which cabinets
and electrical appliances are fitted. In this
case remove the work top of the dish-
washer by unscrewing the screws under
the rear edge of the top (a).
Attention
After removing the work top, the screws must be screwed again
under the rear edge of the top (b).
Selecting the best location for the dishwasher
Step 1.
The installation position of dishwasher should be near the existing inlet
and drain hoses and power cord. Illustrations of cabinet dimensions and
installation position of the dishwasher.
1. 1. Less than 5 mm between the top of dishwasher and cabinet and the
outer door aligned to cabinet.
2. If dishwasher is in stalled at the corner of the
cabinet, there should be some space when the
door is opened.
NOTE:
Depending on where your electrical outlet is,
you may need to cut a hole in the opposite
cabinet side.
90 °
Electrical, drain
and water supply
line entrances
820mm
00
580
580mm
Space between
cabinet bottom
and floor
600 mm (for 60cm model)
450 mm (for 45 cm model)
21
90 °
8
80
100
Dishwasher
Door of
dishwasher
Minimum
space of 50 mm
a
a
b
b
Cabinet
V.1
Publicité
