Samsung QE55LS03AAUXZT Manuel D'utilisation page 7

The remote control does not work.
• Check if the remote control sensor at the bottom of the TV
blinks when you press the remote's Power button.
– When the remote's battery is discharged, turn over the
remote control to charge with indoor light, or use the USB
charging port.
• Try pointing the remote directly at the TV from 1.5-1.8 m away.
• If your TV came with a Samsung Smart Remote (Bluetooth
Remote), make sure to pair the remote to the TV.
Eco Sensor and screen brightness
Eco Sensor adjusts the brightness of the TV automatically.
This feature measures the light in your room and optimises
the brightness of the TV automatically to reduce power
consumption. If you want to turn this off, go to
General > Power and Energy Saving > Brightness Optimisation.
• The eco sensor is located at the bottom of the TV. Do not
block the sensor with any object. This can decrease picture
brightness.
Changing the TV's password
> Settings > General > System Manager > Change PIN
Run Change PIN and then enter the current password in the
password field. The default password is "0000" (France: "1111").
Enter a new password and then enter it again to confirm it. The
password change is complete.
If you forgot your PIN code, press the buttons in the following
sequence to reset the PIN to "0000" (France: "1111"):
On the Samsung Smart Remote: Press
button. > Volume Up > > Volume Down >
.
05 Specifications and Other
Information
Specifications
Display Resolution
3840 x 2160
Sound (Output)
43"-50": 20 W
55"-75": 40 W
Operating Temperature
10 °C to 40 °C (50 °F to 104 °F)
Operating Humidity
10 % to 80 %, non-condensing
> Settings >
Storage Temperature
-20 °C to 45 °C (-4 °F to 113 °F)
Storage Humidity
5 % to 95 %, non-condensing
Notes
• This device is a Class B digital apparatus.
• For information about the power supply, and more information
about power consumption, refer to the information on the
label attached to the product.
– On most models, the label is attached to the back of the TV.
(On some models, the label is inside the cover terminal.)
– On One Connect Box models, the label is attached to the
bottom of the One Connect Box.
(Volume)
• Typical power consumption is measured according to IEC
> Volume Up >
62087.
• To connect a LAN cable, use a CAT 7 (*STP type) cable for the
connection. (100/10 Mbps)
* Shielded Twisted Pair
• The images and specifications of the Quick Setup Guide may
differ from the actual product.
English - 7