Toolland VL2301 Mode D'emploi page 5

6. Assembly
Do not connect to the mains or switch on the leaf blower until fully assembled!
6.1 General Assembly
1. Insert the median hose [a] into the crankcase
while ensuring that it is correctly fitted, inserted
as far as possible and secured with the two
included screws.
2. Fit the wheeled hose [b] into the median hose.
Ensure that it is correctly fitted, inserted as far
as possible and secured with the two included
screws.
6.2 Fitting the Bag
1. Before fitting the collection bag, check that the
function selection lever is in the normal position
and is not hindered by debris from the previous
use.
2. Fold the opening of the collection bag over the
connection and insert it into the lateral holes on
the discharge port [c, d].
3. Attach the front of the bag under the hose
using the bag's retaining clip.
6.3 Fitting the Shoulder Strap
1. The leaf blower is supplied with a shoulder
strap [e]. this is fitted to the bottom of the
crankcase as shown [f].
2. Fit the strap in a position that suits the
operator.
V. 01 – 24/05/2016
VL2301
WARNING
5 ©Velleman nv