Operation - Remote Control; Cleaning And Maintenance - Bestron AAc5000 Mode D'emploi

user's instructions

operAtion - remote control

The appliance can also be controlled using the included remote control. The remote control operates on two
AAA batteries (not included). Open the battery compartment on the bottom of the remote, insert the batteries
and close the lid. The buttons on the remote control work the same as the buttons on the control panel, apart
from the " " function which can not be switched on or off via the remote control.
humidifying
For optimal use:
• The distance between the appliance and the remote control should,nt be more than 6 meters.
• Point the remote control at the appliance and be sure that the angle is smaller than 30 degrees.

cleAninG And MAintenAnce

Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan blades.
Romove any dust with a brush and/or vacuum cleaner.
replacing the water
The water should be changed every 3 - 4 days even when the appliance is not being used.
1. Remove the plug from the wall socket.
2. Remove the intake filter from the back of the device (see figure 3).
3. Unscrew the screw at the top of the cooling/humidification system (see figure 4).
4. Remove the cooling/humidifying system from the device.
5. Remove the water tank from the device.
6. Empty the water tank, rinse it under the tap and dry it thoroughly.
7. Insert the water tank, the cooling/humidification system and the intake filter back into the appliance.
8. Fill the water tank as described under 'OPERATION - Cooling / Humidifying the air'.
• Thoroughly clean the water tank when not using the appliance for a longer period of time.
cleaning the cooling/humidifying system
1. Remove the plug from the wall socket.
2. Remove the intake filter from the back of the device (see figure 3).
3. Unscrew the screw at the top of the cooling/humidification system (see figure 4).
4. Remove the cooling/humidifying system from the device.
5. B end the fastening points of the white cooling/humidifying curtain slightly outwards to remove the curtain
from the cooling/humidifying system (see Figure 5).
6. Clean the cooling/humidifying curtain and the other parts under running water.
7. Thoroughly dry all parts before reassembling and reinserting them into the appliance.
8. Reassemble the cooling/humidification system and insert it back into the appliance.
• Verify that the appliance is not connected to the power supply before you clean it.
• N ever use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
• T horoughly clean the cooling/humidifying system when not using the appliance for a longer period of
time.
3
25
4 5