Bestron ANE1 Mode D'emploi page 19

instruction manual
oPerAtion - fitting the battery
1. Remove all packaging materials.
2. Hold the appliance with the brand upwards.
3. Open the batteryholder by twisting the backside of
the cover a kwarter to the back.
4. Insert a 1.5 V AA battery in the battery holder, with
the plus terminal (+) to the left.
5. Fit the cover back over the batteryholder.
oPerAtion - use
1. Remove the protective cover from the cutting head.
2. Switch on the appliance by pressing the On/Off switch.
3. Insert the small end of the cutting head in your nostril or ear. The appliance will now trim your nose or
ear hair.
4. Switch off the appliance and remove the battery from the battery holder.
5. Fit the protective cover onto the cutting head.
6. Blow your nose to get rid of any loose nasal hair.
• Never use the appliance for purposes other than trimming your nose or ear hair and eyebrows.
• Always insert only the small end of the cutting head in your nostril or ear. Do not press the
appliance too hard into your nostril or ear, and do not insert it too far; this could result in injury.
• Remove solely those hairs that project beyond your nostrils.
oPerAtion - Placing the precision trimmer
1. Remove the cutting head by
slightly turning it counter-clockwise.
2. Place the precision trimmer by
slightly turning it clockwise.
oPerAtion - Precision trimming
1. Switch on the appliance by pressing the On/Off switch.
2. Move the trimmer head diagonally across your skin to remove the unwanted hairs.
3. After use, switch off the device.
cleAning And MAintenAnce
Switch off the appliance and remove the battery. Blow the remaining hairs from the cutting head.
Clean this appliance with a damp cloth and dry afterwards with a dry soft cloth. Don't rinse it under the
water tap and don't use any aggressive cleansers.
13
Figure 2
Fitting the battery
Figure 3
Placing the
precision trimmer