Summit Treestands Viper Steel Mode D'emploi page 8

5
CLIMBING UP / USE / CLIMBING DOWN
CLIMBING UP WITH YOUR NEW STAND
WARNING
!
At this point IT IS MANDATORY AND REQUIRED
that you attach your FBFAHS to the tree and
remain connected at all times after leaving the
ground.
ALWAYS refer to the written FBFAHS instructions
and videos for proper and safe use of your FBFAHS
before climbing.
1. Following the FBFAHS Instructions, attach the
harness tether to the tether strap. Loop the strap
around the tree to secure it. See figure 13.
2. Your RapidClimb stirrups and bungee heel cord
should be already attached to your treestand. To use,
back your heel into the bungee heel cord (figure 14)
then simply slide your boot under the RapidClimb
stirrup. Make sure that your boot is secure under the
stirrup as shown in figure 15.
3. On all models hook the black elastic bungee cord
around the seat as shown in figure 16 to keep it
secure while you climb.
4. To begin climbing, raise your seat platform up to
just below waist height and grasp the upright arms
very firmly as shown in figure 17.
PG 8
13
15
UPRIGHT
ARMS
17
ALUMINUM
VIPER SHOWN
STEEL SIMILAR
ALUMINUM
VIPER SHOWN
STEEL SIMILAR
www.summitstands.com
14
16