Publicité
Les langues disponibles
Les langues disponibles
4
SETUP
SEAT
Your foam seat must be attached to the climber
platform before use. The straps and buckles are attached
and buckled on the bottom of the seat platform.
1. Place your seat platform on a flat surface with the
rear "V" brace facing up.
2. Position the seat inside of the seat platform frame.
3. Wrap the seat strap webbing over the frame from
the inside out as shown in figure 1.
4. Turn the three bar slide slightly sideways and push it
through the metal D buckle that is sewn onto the end of
the strap (figure 2).
WARNING
!
Replace all seat cushions every two (2)
years or sooner if damage or wear is
present.
TRACTION STRIPS
1. Peal the backing off of one of the supplied
high traction strips and apply to the center of the
platform run as shown in figure 3. Repeat for all
5 rungs.
RAPIDCLIMB STIRRUPS
Adjust the stirrups to fit your footwear at ground level.
This is done by loosening the wing-nut and sliding the
stirrup up or down the tube. Re-tighten the wing-nut
once desired fit is achieved. NEVER remove the wing-
nut or stirrups. NEVER slide the stirrup outside of the
acceptable adjustment range showed in figure 4.
!
Moving your foot placement closer to the tree
changes the leverage needed to adhere the
platform to the tree. Attaching the stirrups or
placing your feet too close to the tree may cause
the platform to slide down the tree which could
cause serious injury or death. See figure 4 for
proper foot location.
WARNING
1
The seat included with these treestands is removable
for storage. DO NOT leave your stand outdoors
when it is not being used.
3
4
ACCEPTABLE ADJUSTMENT RANGE
2
NOTICE
PG 5
Publicité
