Fuzzix F500 Serie Manuel D'instructions page 5

OPERATION
Connect the power lead into the fog machine and earthed mains outlet. Then you can switch the power on by ON/OFF switch.
After a certain warm-up time, the fog machine is ready to operate. Then the stand-by LED of the remote control lights up. By
operating the smoke switch on the remote control the smoke emission starts. It may happen that the stand-by lamp turns off and
the smoke emission stops. In this case the device is heating up again and will be ready to operate again.
Switch off when fog machine not used and unplug from mains if not use for long periods.
WIRELESS REMOTE CONTROL
A = Speed auto program of the LED's
B = Smoke on/off
C = Color RGB in several color modes or white strobe mode.
D = power LED on/off
(*) This feature is not available on 160.305
CLEANING
The fog machine must be cleaned to avoid deposits in the machine, pump and heater.
Procedure:
Remove smoke fluid from the tank, fill "smoke machine cleaner fluid"into empty tank.
1.
2. Switch the power on and wait until smoke machine is warmed up.
3. Press on the button of remote control and pump the liquid through the machine.
4. Perform the above operation until the tank is empty.
5. Fill the tank with smoke fluid.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Do not allow the pump to run dry!
(*)
(*)
Run clean procedure in a well-ventilated area!
(*)
5