KRATOS SAFETY FA 10 101 00 Mode D'emploi page 11

the seams (no visible damage), the metal parts (no deformation or rust) and that the connectors work properly (opening/locking). In the event of
deformation or doubt the harness should be withdrawn from service. After a fall the product must not be reused and withdrawn from use (see section
VERIFICATION PROCEDURE).
Do not remove, add or replace any component of the harness.
TECHNICAL CHARACTERISTICS:
Strap material: polyester and/or polyamide. Buckle material: heat treated steel, stainless steel and/or aluminium.
Maximum rated load of the harness 140 kg.
SUITABILITY FOR USE:
The harness must be used as part of a fall arrest system as defined in the product data sheet (EN363) to guarantee that the dynamic force exerted on the
user during the arrest of a fall is maxi 6 kN. A fall arrest harness (including EN361/EN358/EN813) is the only body-gripping device that may be used. It
may be dangerous to create one's own fall arrest system where each safety function can interfere with another safety function. Read the recommendations
on using each component in the system before use.
VERIFICATION PROCEDURE:
The equipment has a service life of 10 years, but this duration may increase or decrease depending on how it is used and/or the results of annual checks.
The equipment should be inspected if there is any doubt, or following a fall, and at least annually, by the manufacturer or a competent person* and in
strict compliance with the manufacturer's periodic inspection procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check
its strength and therefore the user's safety.
*: refer to the definition of a competent person on our website under: Info/Technical Advice
The product data sheet should be completed (in writing) after each verification. The date of inspection and date of the next inspection must be indicated
on the data sheet. It is also recommended to put the date of the next inspection on the product.
SERVICING AND STORAGE: (Comply strictly with these instructions)
During transport, keep the harness in its packaging, well away from any cutting surface. Clean it with water and soap, wipe it with a dry rag and
hang it up in a well-ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same procedure for components
that have become damp during use. The metal parts should be wiped with a cloth impregnated with paraffin oil. Never use bleach or detergents. The
harness should be stored in its packaging in a warm, dry, ventilated place, protected from sunlight, heat and chemicals.
11