Leatt MOTO 2.5 Mode D'emploi page 6

HELMET DESIGNED AND INTENDED FOR USE ONLY IN NON-
AUTOMOTIVE MOTOR SPORTS. NO HELMET CAN PROTECT AGAINST
ALL POSSIBLE IMPACTS. SERIOUS INJURY OR DEATH CAN OCCUR
EVEN WHEN WEARING THIS HELMET. FOR ADEQUATE PROTECTION,
THIS HELMET MUST FIT CLOSELY AND BE SECURELY FASTENED. ANY
HELMET SUSTAINING A VIOLENT IMPACT SHOULD BE REPLACED. THE
PROTECTION OF THIS HELMET MAY BE SEVERELY REDUCED BY THE
APPLICATION OF PAINT, ADHESIVE STICKERS OR TRANSFERS, CLEANING
FLUIDS OR OTHER SOLVENTS. SHELL CONSTRUCTED OF CARBON,
ARAMID, GLASS FIBRES WITH EPOXY RESIN OR POLYCARBONATE / ABS
AND LINER CONSTRUCTED OF EXPANDED POLYSTYRENE. USE ONLY
MATERIALS RECOMMENDED BY THE HELMET MANUFACTURER. READ
AND FOLLOW ALL INSTRUCTIONS IN OWNER'S MANUAL.
Instructions
Do not make any modifications to the Helmet, this includes the outer shell,
the inner EPS liner or chin strap, any and all modifications will void all
warranties and affect the Helmet's performance.
The helmet is suitable for use with goggles.
The liner is essential to the intended performance of the helmet.
The helmet has a limited lifespan in use and should be replaced when it
shows obvious signs of wear, e.g. change of fit, cracks, rust or fraying.
The Leatt ® Helmet forms part of the protective equipment ensemble
available for use by participants in motorcycling activities. Always perform
any motor sport activity with caution and use/wear appropriate safety
equipment.
6
WARNING
Copyright © 2022, Leatt ® Corporation