OW Lee CASUAL FIRESIDE 5110-4272O Mode D'emploi page 8

GEM, MIRRORED AND CRUSHED GLASS MEDIA PLACEMENT
A. Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer.
Do not attempt to install the appliance unless all parts are in good condition.
B. Correct installation is crucial to safe performance of your Outdoor Fire Pit.
C. CAUTION: Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles.
GEM, MIRRORED AND CRUSHED GLASS MEDIA PLACEMENT
Figure 1.
Rectangle Burner Support and
Stainless Steel Burner
Figure 3.
Pour the additional bags of media onto
the burner support. Taper from the top
of the burner towards the width edge.
CAUTION: BURN HAZARD. GEM, MIRRORED and CRUSHED GLASS and LAVA GRANULES
YOU MUST MAINTAIN THE LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF YOUR FIRE PIT.
IF YOU NEED TO REPOSITION ANY MATERIAL TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW MATERIAL ADEQUATE TIME TO COOL BEFORE HANDLING.
CAUTION: Lava granules used in a fire pit are porous and when heated up to normal operating temperature
can cause trapped gasses or moisture to expand and cause a "pop" and "launch" outside of the fire pit, which
could cause injury or property damage. Allow lava granules to completely dry after getting wet, rained on or
Pour the glass gem, mirrored or crushed glass media into the
Outdoor Fire Pit so that the burner is completely covered.
(See Figure 1, 2 and 3)
WILL REMAIN HOT FOR SOME TIME AFTER USE.
hosed off, before lighting and using the fire pit.
Pour the first bag of the glass media
into the burner support.
Page 8
Figure 2.