Samsung WF45N5300A Serie Manuel D'utilisation page 24

Installation
STEP 3 Adjust the levelling feet
STEP 4 Connect the water hose
24 English
WF5300N_DC68-03876C-01_EN.indd 24
1. Gently slide the washer into position.
Excessive force may damage the
levelling feet.
2. Level the washer by manually adjusting
the levelling feet.
3. When levelling is complete, tighten the
nuts using the spanner.
NOTE
An adjustable wrench or 17 mm open-
end wrench is required to loosen or
tighten the leveling feet.
CAUTION
• Make sure you use a new water hoses,
and there are rubber gaskets (B) inside
the couplings (A) at either end of each
water hose. A water hose without the
gasket may leak.
• If there is a water leak, stop using the
washer and contact a local Samsung
service center. A water leak may cause
B
electric shock.
• Do not stretch the water hoses by force.
If a hose is too short, replace the hose
with a longer, high-pressure hose.
A
• To prevent leaks, make sure both water
hoses are not bent or kinked. A water
leak may cause electric shock.
2018-08-13 12:08:00