Publicité
Les langues disponibles
Les langues disponibles
4.
Du ring steam ironing, steam rate will be varied when temperature contrai
dial is adjusted to different positions. This can prevent water leakage
caused from soleplate.
5.
After using, take the iron unit back onto base unit,turn temperature control
dail to "MIN", and then unplug from main socket.
6.
SI ide water tank out from the base unit and empty it.
Note:
a.
For every first time use, it is normal that' s a slightly vibration sound may be
occurred from electrical pump inside the base unit for a few seconds when
steam ironing started. lt is because there is air inside the filter, it will stop till
the air inside the filter has been pumped out. If this abnormal conditions
coutinuously happen for more than 60 seconds, please check whether
water tank and filter assembled correctly or not.
b.
When temperature contrai dial is set at "synthetic" position, it only suits for
dry ironing, max steam will be obtained when set at "MAX" position, when
set at "Wool" steam will be smaller gradually.
Dry ironing
1.
Connect the appliance to a suitable socket outlet.
2.
Set temperature contrai dial to desired position according to ironing
instructions on the garment label or fa bric setting chart. Heating indicator
light (red) at iron unit lights up to indicate the unit being heated up. When
the heating indicator light turn off, the desired temperature has been
reached. During use, heating indicator light will cycle from ON to OFF and
then OFF to ON. lt indicates that the unit is heat preservation.
3.
After using, take the iron unit back onto base unit, turn temperature contrai
dial to "MIN", and then unplug from main socket.
Note: When changing your Temp setting from higher setting to lower, it is
proposed that not to start ironing immediately since it may cause burns to your
fabrics. Please wait till temperature indicator light lights up steadily, and then
start ironing.
Publicité
