Manuels Connexes pour Hyena LED Multi
Sommaire des Matières pour Hyena LED Multi
- Page 1 Product Manual LED Multi (CE-03) Original Instruction Version 231218 Copyright © 2023 HYENA INC. All Right Reserved.
- Page 2 Table of Contents Introduction ....................1 Product Features ................... 1 Product Description ....................1 Parts Description ....................1 Product Dimension....................2 Cable Pin Definition....................2 Technical Data ....................3 Function ......................... 3 Characteristic ......................3 Mounting Parameter ....................3 Connection ......................3 LED Indicator Information ..................
- Page 3 Introduction This manual is intended primarily for the trained technician to install, disassemble, or maintain the Hyena e-bike system only. Please read all the safety warnings and instructions carefully. Failure to follow the warnings and instructions may result in death or severe injuries. Save this manual for future reference.
- Page 4 Product Dimension unit: mm Cable Pin Definition HYENA E-BIKE SYSTEMS...
- Page 5 Left/Right handle bar Clamp diameter 22.2 mm 520 mm (40010C19B) Cable length 600 mm (40010C20B) Standard connector Hyena 6P male CM-WP408-06M Connection Support to HRA (Hyena Rider Assistant ) & Bluetooth connection Bluetooth 4.2 BLE HST (Hyena Service Tool) HYENA E-BIKE SYSTEMS...
- Page 6 (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. HYENA E-BIKE SYSTEMS...
- Page 7 • Carefully install is necessary, do not strike it with any tool such as a hammer or wrenches. Insert the rubber ring. STEP Mount the HMI hook on the rubber ring STEP Fasten the hex bolt. STEP HYENA E-BIKE SYSTEMS...
- Page 8 -The e-bike drive output only supports a speed below 25/45 km/h, as soon as you have reached 25/45 km/h, e-system switches off the assistance, then automatically reactivated when your speed is below 25/45 km/h. > 2 secs HYENA E-BIKE SYSTEMS...
- Page 9 Error alert Red lights flash when a system error is detected. Bluetooth connection 10 seconds Blue lights flash 3 times when Bluetooth connected or disconnected. Loop Flash 3 seconds Error General Alert Mode HYENA E-BIKE SYSTEMS...
- Page 10 Product Label • All the component leads shall use original Hyena • You can find the product number and related information components. on the product.
- Page 11 Étiquette du produit • Tous les manuels et documents techniques du système électrique Hyena sont accessibles en ligne sur le site L'étiquette du produit se trouve en bas de l'HMI et comprend "www.hyena-ebike.com". les informations ci-dessous.
- Page 12 (HMI), es accessoires et l'emballage, doit être éliminée de manière respectueuse de l'environnement. • NE jetez PAS les vélos électriques et leurs composants avec les déchets ménagers. CONSERVEZ CES NSTRUCTIONS HYENA E-BIKE SYSTEMS...
- Page 13 This page is intended to be blank. HYENA E-BIKE SYSTEMS...
- Page 14 Hyena Inc. Tel: +886 4 23598810 Fax: +886 4 23598610 www.hyena-ebike.com Address: No.25, Jingke N. Rd., Nantun Dist., Taichung City 408, Taiwan (R.O.C.) HYENA E-BIKE SYSTEMS...