Manuels Connexes pour Hyena LCD Compact EX
Sommaire des Matières pour Hyena LCD Compact EX
- Page 1 Product Manual LCD Compact EX (CC-02) Original Instruction Version 240315 Copyright © 2024 HYENA INC. All Right Reserved.
- Page 2 Table of Contents Introduction ....................1 Product Features ................... 1 Product Description ....................1 Parts Description ....................1 Product Dimension....................2 Cable Pin Definition....................2 Technical Data ....................3 Function ......................... 3 Characteristic ......................3 Mounting Parameter ....................3 Connection ......................3 Indicator Information .....................
- Page 3 Product Features Product Description The Hyena LCD Compact EX (CC-02) e-bike handlebar HMI features all in one function: compact size with complete info and precise digital information, large ergonomic buttons. In addition, support the Apps and service tool connection via Bluetooth.
- Page 4 570 or 720 29.5 Φ4.0 49.0 Φ22.2 NOTE: The connection length between this HMI to its power supply (controller), including extension cables, shall be limited to under 3 meters. Cable Pin Definition CAN L DEN/HMI CAN H VCC+ HYENA E-BIKE SYSTEMS...
- Page 5 Turn on/off light Long press Up button Walk-assist Refer to page 7 USB charging Max. 5V/1A USB 2.0 TYPE A Connection Bluetooth / USB 3.0 / Hyena 6P Battery wake up function HMI/DEN Characteristic Protocol Support Hyena CAN Rated voltage 12Vdc...
- Page 6 0 to 99 Unit in 1 km/hour or 1 mi/hour Unit in 1 km or 1 mi Range 0 to 99 (Battery with Hyena CAN required) Riding support level 0 to 3 0-4 on specific models Battery status 5 segments...
- Page 7 • Carefully install is necessary, do not strike it with any tool such as a hammer or wrenches. STEP Mount the HMI hook on the handlebar. STEP Mount and fasten the hex socket head screw with torque to 0.25 Nm (2.5 kgf/cm). HYENA E-BIKE SYSTEMS...
- Page 8 -The system is activated as soon as you start pedaling. -The e-bike drive output only supports a speed below 25/32 km/h, as soon as you have reached 25/32 km/h, the e-system suspends the motor support, then automatically reactivates when your speed is below 25/32 km/h. HYENA E-BIKE SYSTEMS...
- Page 9 Make sure you are ready and stand steady before activating the walk assistance. Do NOT activate the walk assistance when you ride on the e-bike or if the wheels are not in contact with the ground. HYENA E-BIKE SYSTEMS...
- Page 10 Battery Short Circuit USB Charge Port Error Battery Battery Overdischarge Front Light Front Light Malfunction Battery Discharging Temperature Error Misc. Maintenance Notification Battery Battery Cell Balancing Error Misc. Brake Sensor Error Controller Controller Overheat Rear Light Rear Light Malfunction HYENA E-BIKE SYSTEMS...
- Page 11 • Do NOT drop the product from more than 30 cm (11.81 output cable is frayed, has broken insulation, or any inches) in height. other signs of damage. • All the component leads shall use original Hyena Maintenance components. • Do NOT clean the product or any e-system component •...
- Page 12 É tiquette du produit • Tous les manuels et documents techniques du système électrique Hyena sont accessibles en ligne sur le site L'étiquette du produit se trouve en bas de l'HMI et comprend "www.hyena-ebike.com". les informations ci-dessous.
- Page 13 (HMI), es accessoires et l'emballage, doit être éliminée de manière respectueuse de l'environnement. • NE jetez PAS les vélos électriques et leurs composants avec les déchets ménagers. CONSERVEZ CES NSTRUCTIONS HYENA E-BIKE SYSTEMS...
- Page 14 Hyena Inc. Tel: +886 4 23598810 Fax: +886 4 23598610 www.hyena-ebike.com Address: No.25, Jingke N. Rd., Nantun Dist., Taichung City 408, Taiwan (R.O.C.) HYENA E-BIKE SYSTEMS...