Thermador An American Icon WD24 Mode D'emploi page 6

3) Install Warming Drawer
4) Attach Custom Drawer Front
(Optional)
7) Connect Electric
8) Test the Installation
Service
English 4
Slide warming drawer assembly into cutout and over support brackets (if applica-
ble) until it is flush with cabinet. Secure through four screw holes in front frame
(Drill pilot holes in cabinet first if necessary.).
CAUTION: Use care when handling glass panel to avoid breaking. Broken glass
could cause injury.
1) Prepare custom drawer front as explained above.
2) Remove drawer from warming drawer frame (See Use and Care Manual for
instructions).
3) Remove two screws from backside of drawer front. Set handle and screws
aside.
4) Remove signal light viewer and retainer clip from glass panel and set aside.
Discard glass panel (Note: stainless steel models do not have a glass panel).
5) Install the signal light viewer and the retainer clip in the custom drawer front.
6) Attach drawer front with two screws. Attach handle as well if desired.
Insert plug into three-prong, grounded outlet. See "Power Requirements and
Grounding", above for electrical specifications.
Turn the warming drawer on. Signal light turns on immediately. Wait five minutes
and then place palm on drawer bottom. It should be warm to the touch.
If the warming drawer elements or signal light do not turn on, check the power
source to see if the circuit breaker is tripped.
Check the Use and Care Manual for other troubleshooting techniques.
If problems persist, contact Service (see contact information at the front of this
manual).