Axkid ENVIROBABY Manuel D'instructions page 16

Installation in the car
AXKID ENVIROBABY can be installed in the car together with the AXKID ENVIROBASE or with belt installation with a three-point belt,
see Allowed and disallowed positioning of the AXKID ENVIROBABY.
AXKID ENVIROBASE installation
To use AXKID ENVIROBABY together with AXKID ENVIROBASE, see the
installation.
@
info@axkid.com www.axkid.com/manuals
IMPORTANT: Make sure that the handle is in position A1.
Belt installation
10
Start by placing the infant car seat in the correct vehicle seat position.
11
Adjust the handle of the infant car seat to position A1.
12
Pull out sufficient length of vehicle seat belt (T, U) around the infant car seat and buckle the vehicle belt (S).
13
Guide the vehicle' s lap belt (T) through the belt guiding hooks (D) on the infant car seat and tighten the lap belt.
14
Pull the vehicle' s shoulder belt (U) around the seat and fix it in the belt guiding hook (F) on the rear of the infant car seat.
Push down the infant car seat in the vehicle' s seat and then pull the belt as tight as you can to make sure that the infant car seat
15
gets the most fixed position possible. Make sure there is sufficient space between the infant car seat and the car seat behind it.
Axkid has equipped the AXKID ENVIROBABY with a side impact protection system, ASIP (Axkid Side Impact Protection). Pull
16
the ASIP (H) towards the door of the car until it locks in its outer position.
IMPORTANT: Do not use any other vehicle seat belt routing then described in this manual. It could lead to the infant car seat not being
properly fastened which can lead to serious injuries in the event of an accident.
manual for AXKID ENVIROBASE
16
for full instructions of