BorMann PRO BPA1118 Mode D'emploi page 3

EN
Maintenance
Regularly check the bolts and power lines of fixed micro electric hoist, and remove the dust and corrosive liquid which is accumulated on the wire.
Lubricating oil
Miniature electric hoist has a lifetime maintenance of oil, This is normal that there may be a small amount of leakage during operation of the electric hoist,
especially during the first operation, no need to refuel.
Steel rope
Miniature electric hoist requires periodic inspection and replacement of wire rope, If the wire rope is worn, please replace immediately.
Model:
Steel rope specifications:
Installation diagram
Steel rope winding method
Troubleshooting
Regular failure
Motor does not working after pressed the switch
Motor noise, hang load after pressed the switch
Machine can't brake or excessive decline after
power off
Abnormal noise increases
Electric leakage
Limit failure
3
BPA5118
4mm x 12m
Kg. X Kg. 2X
Main reason
1. Power off.
2. Broken or loose wiring.
3. Switch failure.
4. Capacitor burn out.
5. Limit is not reset or overtravel-limit switch
failure.
1. Power supply voltage is too low.
2. Capacitor damage.
3. Brake pads not completely disengaged.
1. Brake clearance is too wide.
2. Brake spring break.
3. Brake wear.
4. Brake pads are heavily contaminated.
1. Poor lubrication.
2. The gear bearing damage after long term use.
3. Poor assembly or bump after the demolition.
1. Grounding failure or no grounding.
2. Inner wire bump.
1. Overtravel-limit switch failure.
2. Limit block.
WWW.NIKOLAOUTOOLS.GR
BPA1118
6mm x 12m
Solution
1. Power on.
2. Check wiring repair.
3. Repair or replace switch.
4. Switching capacitor.
5. Check limiter & exchange ovetrange overtravel-
limit switch.
1. Adjust the supply voltage.
2. Switching capacitor.
3. Brake clearance adjustment.
1. Brake clearance.
2. Replace brake spring.
3. Replace the brake pads or adjusting clearance.
4. Clean brake plane.
1. Foot grease.
2. Check gear or bearing.
3. Re-check the fittings repair bump part.
1. Check the grounding wire
2. Check repair wiring.
1. Repair or replace overtravel-limit switch.
2. Inspection, repair limit.