Télécharger Imprimer la page

BOMANN DB 765 CB Mode D'emploi page 29

Masquer les pouces Voir aussi pour DB 765 CB:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
Steam Ironing ( )
For this a high temperature is needed (cotton, linen).
The quantity of steam can be regulated using the steam quantity
regulator (4). Push it down if necessary in order to turn it.
„O"
no steam
"
Small steam volume
„ "
Large steam volume
Extra steam can be added with the steam jet function „ " (3).
Turn the button to the symbol and press it intermittently.
WARNING: The steam is hot. Danger of scalding!
NOTE:
When ironing at low temperatures (minimum temperature level
„• •"), make sure that you reduce the quantity of steam or iron
without steam.
If the temperature is too low water may leak from the sole-
plate.
Refilling the water tank
Always disconnect the mains plug before refilling water.
Set the steam control (4) to „O" (no steam). Fill in water
through the filling hole (6). Using a filling container. Do not
exceed the maximum line as marked on the water reservoir.
Spray Function ( )
In order to moisten a section to be ironed press the spray button
(3). Turn the button to the symbol and press it intermittently.
Vertical Steam
This can be used to produce a jet of steam in a vertical direction.
NOTE:
To avoid excess water leaking from the soleplate do not
operate the steam burst for more than 5 seconds without
interruption.
Self-Cleaning (
)
1. Half fill the water tank with water.
2. Heat the machine up to its maximum temperature. After the
control lamp goes off remove the machine from the mains
supply.
3. Now hold the iron horizontally over a sink. Turn the steam
quantity control to the „
Now rock the device backwards and forwards until the tank
is empty. Reinsert the control, paying attention to the guide
mechanism. Then return the regulator to the „O" position.
4. Place the machine back on its stand and heat it up again. To
clean the base now iron over a clean cotton cloth.
" position and pull it out.
Cleaning and Storage
WARNING:
The device must never be immersed in water!
Always remove the mains lead before cleaning!
Clean the casing with a slightly damp cloth.
Clean the iron with a slightly humid cloth.
Always return the steam regulator to the „O" position after
use and empty the water tank in order to prevent any leaks.
Technical Data
Model: ...........................................................................
Power supply: ............................................................230 V, 50 Hz
Power consumption: ...........................................................2000W
Protection class: ........................................................................... Ι
Net weight: ........................................................................1,06 kg
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!
Disposal
Meaning of the "Dustbin" Symbol
Protect our environment: do not dispose of electrical equipment
in the domestic waste.
Please return any electrical equipment that you will no longer
use to the collection points provided for their disposal.
This helps avoid the potential effects of incorrect disposal on the
environment and human health.
This will contribute to the recycling and other forms of reutilisa-
tion of electrical and electronic equipment.
Information concerning where the equipment can be disposed of
can be obtained from your local authority.
DB 765 CB
29

Publicité

loading