Trebs Comfortcam 99512 Mode D'emploi page 40

Mounting the camera using the handlebar grip:
1. Place the handlebar grip on the handlebar.
2. Add the screw and nut to hold the handlebar grip securely.
3. Slide the camera into the handlebar grip and make sure the handlebar
grip is locked with the camera.
4. Adjust the angle of the camera.
Mount camera with car holder:
Mount the camera with a suction cup on the windscreen of the car.
Battery Installation
1. Unscrew the cover at the end of the unit.
2. Place your finger on the 'lip', which is on the bottom
half of the rear of the unit, and open the battery slot door.
3. Insert 2 x AAalkaline batteries into the battery slot
according to the polarity direction as shown.
4. Close the battery slot door and screw on the end of
unit cove
Important: When the battery is low, the low battery icon
Always upload video footage to your PC prior to
replacing batteries to avoid memory loss
Note:
a) Do not mix old and new batteries together. Replace
both batteries at the same time.
b) Remove the batteries if the camera is not going to
be used for long periods of time. This will save battery
life.
c) Do not mix alkaline, standard (carbon-zinc) or
rechargeable batteries (nickel-cadmium). Only
batteries of the same or equivalent type as
recommended are to be used together.
d) Non-rechargeable batteries are not to be recharged.
will appear on the LCD display.