Xoro HTL 2231D Mode D'emploi page 79

The recorder works only in DVB-T mode. You can record only DVB-T broadcast. Please pay attention
to following rules:
1. Connect USB storage to the USB port on the left side.
2. Prepare the USB storage by the TV set before starting recording
3. Do not disconnect the power during recording.
Preparation of USB Storage for Recording
1. Press the MENU button to select CHANNEL.
2. Press the ▲▼ button to select PVR File
System and press the ► or OK button to
enter the sub-menu, as shown.
3. Press the MENU button to return to the
previous menu.
4. Press the EXIT button to exit.
Select Disk
Select a disk to store the recorded file. Press the ▲▼
button to select Select Disk and press the ► or OK
button to prompt a submenu, as shown.
•
The item Disk is highlighted and press the
◄► button select desired disk. The available
item varies depending on the external USB
device connected to the unit.
•
Press the ▼ button to highlight OK and
press the OK button to confirm.
Check PVR File System
Press the ▲▼ button
System and press the ► or OK button to start to
check the PVR File system.
After checking PVR file system, the item "USB Disk"
will display "Pass" indicating the file system in the
USB disk connected has been checked and ready to
use.
If the USB disk does not have a PVR File System,
then unit will prompt a message asking user to format it.
Recorder
to select Check PVR File
HTL 2231D
27