Sealey SPI10S Traduction De La Notice Originale page 11

PROBlEM
Green LED is flashing and
the display shows CHArge
ABOrteD-BAD BAttery.
the display shows
COnneCt ClAMPS.
18. SPECIFICATIONS
input .................................................................................................. 230V Ac~50Hz, 2.0A
output ............................................................................................................... 12V
ingress Protection rating ..............................................................................................iP20
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
Environmental Protection
recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner which is compatible with the environment.
WEEE Regulations
Dispose of this product at the end of its working life in compliance with the Eu
Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. contact your local solid waste authority for recycling information.
nOte: It is our policy to continually improve products and as such we reserve the right to alter data, specifications
and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any
claim.
POSSIBlE CAUSE
The battery is too large for the
charger.
The battery voltage is still below
10V after 2 hours of charging.
the clamps are not making a good
connection.
The fuse is bad.
Sole UK Distributor,
Sealey Group.
Kempson Way,
Suffolk Business Park,
Bury St. Edmunds, Suffolk.
iP32 7Ar
•
11
REASON/SOlUTION
You need a charger with a higher
amp rate.
Have the battery checked.
check for poor connection at
battery and frame.
replace the in-line fuse for the ring
connector.
Web
•
www.sealey.co.uk
sales@sealey.co.uk
01284 757500
01284 703534
10A