AEG DL 6250 Manuel D'utilisation page 4

4 www.aeg.com
The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
60cm from electric cookers and 65cm from
gas or mixed cookers. If the instructions for
installation for the gas hob specify a greater
distance, this must be adhered to.
4. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
1. ON/OFF lighting
2. OFF motors
3. - 4. - 5. Minimum suction power (3.),
medium (4.), maximum (5.).
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
5. LIGHTING
Disconnect the hood from the electricity.
Warning! Prior to touching the light bulbs
ensure they are cooled down.
Replace the damaged lamp using 11W PL
lamps only (G23).
1 2 4
3 5
6. MAINTENANCE
ATTENTION! Before performing any
maintenance operation, isolate the hood
from the electrical supply by switching off at
the connector and removing the connector
fuse. Or if the appliance has been
connected through a plug and socket, then
the plug must be removed from the socket.
The cooker hood should be cleaned
regularly (at least with the same frequency
with which you carry out maintenance of the
fat fi lters) internally and externally. Clean
using the cloth dampened with neutral liquid
detergent. Do not use abrasive products.
Warning! Failure to carry out the basic
cleaning recommendations of the cooker
hood and replacement of the fi lters may
cause fi re risks. Therefore, we recommend
observing these instructions.
The manufacturer declines all responsibility
for any damage to the motor or any
fi re damage linked to inappropriate
maintenance or failure to observe the above
safety recommendations.
6.1 Grease fi lter - The grease fi lter must
be cleaned once a month using non
aggressive detergents, either by hand or
in the dishwasher, which must be set to a
low temperature and a short cycle. When
washed in a dishwasher, the grease fi lter
may discolour slightly, but this does not
affect its fi ltering capacity.