Télécharger Imprimer la page

Black Max BM80721 Manuel De L'opérateur page 17

Publicité

Les langues disponibles

Les langues disponibles

OPERATING THE PRESSURE WASHER
See Figures 15 - 16.
As sold, this unit is designed for use with "downstream" pres-
sure washer detergents. To convert for use with "upstream"
detergents, contact an authorized customer service center
for more information.
USE ONLY DETERGENTS DESIGNED FOR PRESSURE
WASHERS. Do not use household detergents, acids, alka-
lines, bleaches, solvents, flammable material, or industrial
grade solutions, which can damage the pump. Many de-
tergents may require mixing prior to use. Prepare cleaning
solution as instructed on the solution bottle. Always test in
an inconspicuous area before beginning.
To clean:
 Disconnect pressure washer from power supply.
 Pour detergent in the detergent tank.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any detergent
is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.
 Install the blue or black soap nozzle on the spray wand.
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
OPERATION
NOZZLE SELECTION GUIDE
(NO SOAP WHEN USING THESE NOZZLES)
 Recommended Nozzle
Page 13 — English
 Squeeze the trigger and wait approximately 5 seconds
for the detergent to appear.
 Start the pressure washer and spray the detergent on
a dry surface using long, even, overlapping strokes. To
prevent streaking, do not allow detergent to dry on the
surface.
To rinse:
 Using the 15º nozzle, spray away from the rinsing surface
for approximately 10 seconds to allow any remaining
detergent to be flushed from the line.
 Start at the top of the area to be rinsed and work down,
overlapping the strokes.
Before shutting off the motor:
 Fill the detergent tank with clean water.
 Spray the clear water through the spray wand until the
tank is empty.
 If any soap remains in the spray, repeat with a second
tank of clean water.
 Shut off the motor.
NOTE: Shutting OFF ( O ) the motor will not relieve pressure
in the system. Pull trigger to release water pressure.
HIGH PRESSURE
Turbo Nozzle
Use With Caution for Certain Applications
LOW PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Blue or Black
15º
Soap Nozzle

Publicité

loading